Relay Module

Relays are electrically operated switches. A small current passing through one side will operate a physical switch. This means that you can control almost anything with a relay that you would turn on and off with a physical switch (batteries, motors, even mains-powered electic lights).

Pretty much all relays are electromagnetic - this means that there is a coil of wire inside that creates a magnetic field that operates a switch. When this coil is turned off it creates Back EMF which can cause damage to your Espruino unless it is protected (with a diode). The Espruino Board will also supply a maxiumum current of 25mA on each pin, which is too small to make a lot of relays work unless you provide some simple form of amplification. This is covered in many places so we won't go into it here.

However many companies supply 'relay modules' that contain one or more relays, screw terminals, and the circuitry needed to drive them easily from Espruino. These can be controlled simply by connecting GND, VBAT (5V), and any signal pin from Espruino.

Relay Module

You can see the relay module we'd suggest in the image above. To use this as a simple switch, wire up:

The connections are as follows:

Blue Screw Terminals

Marking Function
Output 1 Normally Closed
K1 Output 1 Pole
Output 1 Normally Open
Output 2 Normally Closed
K2 Output 2 Pole
Output 2 Normally Open

4x1 pin strip

Marking Function
GND Ground
IN1 Control for Output 1 ( 0 = on, 1 = off)
IN2 Control for Output 2 ( 0 = on, 1 = off)
VCC 5V input

Note: IN1 and IN2 must be connected to 5v tolerant pins on your Espruino board (pins not marked with 3.3v on the pinout diagram). If you must use a non 5v tolerant pin, you can sometimes remove a jumper from the relay and power the relay from 5v while powering the optoisolator from 3.3v - however this will depend on your relay module.

3x1 pin srip

This contains a jumper between VCC and VCC-JD. This means that the relay will be powered from the same 5V signal as the Opto-isolators and LEDs.

Connecting to the Pico

Relay Module on Pico

Jumpers on Relay Module

The Espruino Pico Starter Kit comes with breadboard and male Jumper Wires. To connect to the relay, take the 4 supplied black jumpers and place them on the 4 male pins of the Relay Module. You can then push the Jumper Wires into the top of them.

We'd suggest that you connect Relay GND to Espruino GND, and relay VCC to Espruino VBAT. The two inputs can then be connected to any of the IO pins.



You can buy relays from any electrical component supplier. However, as discussed above, we'd suggest that you don't connect a relay directly to Espruino.

Instead, think of buying a Relay Module. These are available from many places, but eBay is probably the easiest. Look for 'Relay Module 5V' to ensure that you get one that can be powered from a simple 5V power source. In addition to the big block on the PCB that is the relay, look for smaller black chip (not a transistor). This probably means that there is an opto-isolator on board, which provides better isolation than a normal transisitor.

This page is auto-generated from GitHub. If you see any mistakes or have suggestions, please let us know.